Results 3,511 to 3,520 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
10-08-2016, 06:03 AM #3511
- Join Date
- Sep 2016
- Posts
- 2
I've checked the PS connections several times. will try to tighten the rest of connections.
-
10-08-2016, 07:42 AM #3512
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
Pac-Man ghosts in clear Makergeeks PLA. Click the link to see. I don't know another way to add a video!
http://vid58.photobucket.com/albums/...ps74lljos2.mp4
-
10-08-2016, 12:58 PM #3513
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 01:05 PM #3514
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Fluctuation of 2 degrees in temp reading is normal. Blacking out, not so much. Pay particular attention to the power supply cabling and spade lug crimping etc. Could be a bad connection from the PS to the main board. Also look out, the folks assembling these units DO NOT always follow the RED=+, BLACK=- conventions.
-
10-08-2016, 01:06 PM #3515
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 02:15 PM #3516
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 02:21 PM #3517
- Join Date
- Sep 2016
- Posts
- 80
I didn't do rafts, just had blue tape. Scotch, not Blue Hawk.
IIRC, as I said on most of my prints, the skirt is crap and mostly doesn't stick (and with the little feet there's a bunch of small skirts) but the main printing is fine.
Here's the factory file I saved at the time: https://www.dropbox.com/s/ulwiqk7u8o...t.factory?dl=0
-
10-08-2016, 03:07 PM #3518
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
I have found using minimal rafts is the key. I am now able to do 6 at 50% at a time. Fills the bed but it's the size in my video. With the rafts the feet stick great and you can go at full speed.
-
10-08-2016, 04:29 PM #3519
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 04:50 PM #3520
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
Sending a set to my sister and who knows who may buy some sets. The light kit comes with five lights. They take forever to print!
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery