Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 42

Threaded View

  1. 05-30-2015, 12:27 PM #37
    rhonal89
    rhonal89 is offline
    Technologist
    Join Date
    Nov 2014
    Posts
    138
    That's what I did. I had all the same problem you had even worse my servo would move up and keep moving even after autobed level. So installing clough42 firmware fixed everything. Also don't forget to update your e-steps extrusion rate. Since is calibrated for the belt extruder. You need to calibrate it for the Gregg extruder. Look up Tom's video on YouTube on how to.
    Last edited by rhonal89; 05-30-2015 at 12:37 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules