Results 1 to 10 of 42
Threaded View
-
05-26-2015, 07:57 AM #7
- Join Date
- May 2015
- Posts
- 107
Thanks sniffle but the display was not the only thing. I opened Ponterface and could get no response from the printer on ANY commands. But, I will go back through the config_h again. Most likely just something small I forgot or configured wrong.
So...why couldn't I just use the firmware Makerfarm suggests using and add the sections for ABL to it from the 1.0.2 tag? Just a cut/paste command and done!
Or, is it not that easy??
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help