UPDATE: I took the plunge! I downloaded and installed the firmware Itty Bitty Belted Extruder: i3v_itty_bitty.zip from Clough42's website. You were right (again) Roxy. It was "load and go". I no longer have the twitch. When I send a "home" command, the hotend raises BEFORE the probe retracted...perfect!

I have only tried the G28 and G29 commands so I have not tested anything further, so at this point i can only clain the G28 and G29 commands work perfectly.


So...why can't the BeckDac branch take the firmware clough42 did and fix the issues it is haveing? Seems like trying to figure out the bugs when here is already a fix is like re-inventing the wheel. But then again, I am new to 3d printing and have no clue what it takes to wright pages and pages of code!