Convering to ABL and having issue with Z axis

[Roxy]

Ponterface commands do nothing. I get an error:

"Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)"

It kind of sounds like it is reading the temperature with the wrong values. Like it is assuming the wrong thermistor or trying to get the reading off of the wrong pin.

Nothing on the display etc. I don't know what you guys did to make your makerfarm i3v8 work with ABL, but it doesn't seem to want to work here. Of course, it could be me but that would mean I would have to admit fault and take responsibility!! YIKES!

Is there already firmware configured for this with ABL?

I believe the BeckDac branch will just load and go. And if not it will be very close to doing that.

You can get that here: https://github.com/beckdac/Marlin