Results 1 to 10 of 42
Threaded View
-
05-26-2015, 04:08 PM #11
- Join Date
- May 2015
- Posts
- 107
No Luck!!! I uploaded the original firmware from Makerfarm back into the machine. Everything seemed to work fine. I then opened up the 1.0.2 tag and also opened the original firmware. I compared the two making changes to the 1.0.2 tag to match the original makerfarm firmware. (of course leaving in the ABL section). I got the same issues/problems. I then re-downloaded a fresh copy of 1.0.2 tag and just uploaded it with out changing anything. Got the same thing. Ponterface commands do nothing. I get an error:
"Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)"
Nothing on the display etc. I don't know what you guys did to make your makerfarm i3v8 work with ABL, but it doesn't seem to want to work here. Of course, it could be me but that would mean I would have to admit fault and take responsibility!! YIKES!
Is there already firmware configured for this with ABL?Last edited by huntleybill; 05-26-2015 at 06:07 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help