Convering to ABL and having issue with Z axis

[Roxy]

Hi Roxy
I had the deploy and retract settings at 85/5. I chnged them incrementally by one and wound up at 87/3. It has NOT eliminated the problem but it is less noticable. As for servo shutoff, It must not be set because the probe continues to jump around throughout the print process. (and i don't see anything in RC Servo Support section that references a shutoff)

You can try going the other way too... 84 / 6 . The Servo Shut Off delay is controlled by:

#define PROBE_SERVO_DEACTIVATION_DELAY 500

(The 500 is in milliseconds. The default is 1/2 second)