Results 1 to 10 of 396
Hybrid View
-
09-24-2014, 09:21 PM #1
- Join Date
- Sep 2014
- Posts
- 12
Something else to look at in the configuration.h, right about that line it says :
//If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk
//The value is the delay to turn the servo off after powered on - depends on the servo speed; 300ms is good value, but you can try lower it.
// You MUST HAVE the SERVO_ENDSTOPS defined to use here a value higher than zero otherwise your code will not compile.
-
09-24-2014, 09:24 PM #2
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I tried that, it threw many more errors which I can't remember well enough to quote right now.
Yes, I saw that too. I used the deactivation delay before this fork came out, so it was working properly before. I have it set up properly.
Comparing the new version with what I was using yesterday, that whole "Retract Z Servo endstop if enabled" section is new. I commented it all out for now.Last edited by AbuMaia; 09-24-2014 at 09:32 PM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials