Results 3,051 to 3,060 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
09-13-2016, 05:57 PM #3051
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
09-13-2016, 08:02 PM #3052
I look forward to seeing the finished form.
You have that dialed in quite well.
What filament are you using?Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
09-13-2016, 08:08 PM #3053
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
09-13-2016, 08:22 PM #3054
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-13-2016, 08:37 PM #3055
Nice!
I am printing with ESun PeTG right now. First print was good except for the screw tab sagged on the SD Card holder model. Now I am working on bed leveling knobs. Been getting about 25% through the print and a glob invariably happens and pulls one or more of the models off the bed. I am going to try and print just one this time.
I did bite the bullet and buy Simplify3D. Liking it so far.
Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
09-13-2016, 09:44 PM #3056
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-14-2016, 12:35 AM #3057Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
09-14-2016, 12:49 AM #3058
-
09-14-2016, 01:06 AM #3059
-
09-14-2016, 01:12 AM #3060
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery