Results 1 to 10 of 31
Threaded View
-
08-03-2016, 08:40 AM #23
The Titan appears to be a fairly new, geared extruder from e3d. Looks promising. No one has posted in the MakerFarm subforum about using it on a MakerFarm printer yet. Note that the "standard" extruder on Pegasus is a direct drive, without any gearing. Because of torque limitations from the extruder stepper motor without gearing, that limits you to 1.75mm filament.
The insulating material goes between the heat bed and the Y-bed plate that the heat bed sits on.Last edited by printbus; 08-03-2016 at 11:04 AM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion