Quote Originally Posted by Syd_Khaos View Post
Of course you haven't...
Almost everything I have printed needing glued together has been done with superglue. And not a single thing has come apart yet. Some things have been well tested too.
Don't know what to tell ya. Only thing I can think of is the parts are not going together well enough for glue to create good bond.
I tried to compensate for poor design choices by gluing a part back together which had broken under stress. (You all know how this story goes.) First I used super glue, a Loc-tite Ultragel variety, it appeared to work but came apart under mild stress. I next tried acetone on both surfaces, waited a few seconds and then forced them together for 5 minutes with mild finger pressure. It seems to have worked, at least long enough to get the assembly together. The process of assembly was actually the stress factor, so it will hopefully remain functional in place. At least until I have to take it apart and reassemble it. ;-)