Results 1 to 10 of 12
Threaded View
-
02-01-2016, 12:35 PM #3
You think the speed will be alright though?
And to your knowledge, is there any software that'll allow replicated prints that fully print, then bring the Z-axis back up, and start again further over on the X/Y - like the way a laser cutter prints, only with the up/down movement too. Because then I could line 5 next to each other and fully print each one, allowing the hot end to cool down by 5 degrees each time.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion