Quote Originally Posted by Roxy View Post
Clough??? Did adding the Z_RAISE_AFTER_PROBING fix the problem?
Thanks, Roxy. It's working well for me. I've got about 35 hours of continuous printing on it now, and its looking solid.

I do have a little oddity with the bed leveling I can't figure out. The probe results show that the bed is not flat. The readings at the right edge and the middle of the bed are just about the same, but the readings at the left edge are a tenth of a mm or so lower. But with a straightedge and .05mm feeler gauge, it seems completely flat to me.

It's odd, and it after the leveling, the z seems to rise linearly when moving to the left, so stuff on the left side of the bed doesn't adhere well.

I would have expected the opposite, dropping as it moves left, compromising on the first layer being tight in the middle..

I can't get the diagnostics right now, because it's currently printing.