Results 1 to 10 of 13
Threaded View
-
07-13-2015, 06:53 AM #10
one thing that might make a difference is the difference between print speed and travel speed.
If you print at say 50mm/s and have your travel speed at 100mm/s I find that the sudden acceleration often pulls soft filament up and creates those sort of peaks that heads will catch on.
These days I pretty much make the travel and print speed the same. This avoids the pulling on soft filament.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help