Quote Originally Posted by G.EVE View Post
hi
you can try magic and fix your naked edge or anything else that may cause if fail //// maybe its not bolin
Magic, eh? Been a while since I talked to the coven. I wonder if they still have my wand...

Pretty sure there aren't any naked edges or bad surfaces on the model. Usually, if there's a bad surface or naked edge on the model, the problem areas occur in the same spot every print, in the vicinity of the bad surface or naked edge. I don't think that's it but I will double-check with a few third-party programs just to make sure.

Bolin? Do you mean Boolean? Yes I used the Boolean Union command in Rhino to make the model into one watertight mesh for printing.