Results 1 to 10 of 102
Thread: Itty Bitty Double FLEX Extruder
Threaded View
-
05-27-2015, 09:09 AM #12
Thanks!
Honestly, never had the Z banding issue...my z rods are stock and yes, they wobble at the top a bit.. I dont try to constraint them. Just them be.
I did make sure my entire assembly was square from the very beginning and belts are tight. I used calipers to make sure that both extrudes for the X carriage we even at both ends, then tightened it all up.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help