Results 1 to 10 of 476
Thread: Itty Bitty Double Extruder
Threaded View
-
12-30-2014, 08:35 PM #11
- Join Date
- Nov 2014
- Location
- Orange, CA
- Posts
- 78
Well i have been trying to print this for the last 2 days nothing has worked to hold ABS down
i can print all day in play and it comes out flawless using hairspray but in ABS the stuff just pops off the bed after about 30 layers and not just this any thing i print in ABS seams to do this
can i get links to other known good ABS filaments and maybe some known good slic3r ABS settings
i tried low in fill 10% + 3 shells(and more) , tried cura 14.09
i can't even get 5mm tall 10x10 calibration cubes to stick to tune abs flow
even a raft falls off the bed
room temp 76deg F dead air no fans
things tried
hairspray
glue stick
abs slurry
kepton tape
even frog tape
i print with abs all day at school and never have problems like this so i think it's this cheep eSun (prototype supply) ABS
the PLa i get from prints better then any PLA i have used but I'm starting to think they suck at ABS
added note if anyone needs belts i ordered mine off aliexpress i have them now in hand i have 52 of them left (my 1/8 on-road R/C uses them to lol )
i have 30 of the 188mm used on the single extruder ver of this as wellLast edited by TechMasterJoe; 12-30-2014 at 08:51 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion