Results 1 to 10 of 396
Threaded View
-
11-08-2014, 03:40 PM #11
It isn't a setting. The code is different. If you are running Dacb's MakerFarm fork of Marlin, you should have it. And, unless you are giving the G29 the E option, it is only going to engage the Z-Probe once at the start. It will wait until the Z-Probe is raised at the end to unengage the probe.
Last edited by Roxy; 11-08-2014 at 04:02 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion