Results 1 to 10 of 27
Threaded View
-
09-12-2014, 01:38 PM #7
- Join Date
- Jul 2014
- Location
- Munich
- Posts
- 45
first sorry for so long no news but I was a bit busy so no time to go on, additional I have a small issu with the transfer of the pic to the computer
I hope to solve the issue with the pics tommorow han can give you a lot of new views.
What I did today was uploard the firmware and check the first points
so far thermistor headbed and the heatbed themselve are working
with my ground adjustement of the Polols Z is working good so far only a seldom sound is hearable but this could be also bec the spindles are dry at the moment this will check later.
after readjust my Y belts this is also working.
X was making trouble but after a while ( sitting in front and not understanding anything anymore ) i get it , stupid issue from my side I connected the motors like i do usual but here the motors need to run in opposide directions ,
after the connector was turned the X is now also moving.
I´ll sit don now I try to finish the Hotend (thermistor and heater not connected yet)
Will update tomorrow plan would be to finish all and start calibration.
br
Thomas
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion