Results 1 to 10 of 126
Thread: Z axis calibration idea
Threaded View
-
09-11-2014, 09:32 PM #38
- Join Date
- Sep 2013
- Posts
- 308
Hey Aztecphoenix
It may be a little while before we get to it, but we will likely write software right in to the peachy driver/ printing interface that is meant to detect capacitive feed back.
The testing we have done here at peachy confirms most of what you said about capacitive feed back. We havent Graphed temperatures affect and im really curious to know more about that.
Since your actualy doing this, it might be good to start a new thread to document your work in. If you can be very descriptive (vids and pics of what you have set up ) Ill be more able to get involved.
There is also this Thread on the topic of Capacitive feed back, and there you can see that colehard has made some progress on this as well.
http://3dprintboard.com/showthread.p...gt-freq-gt-mic
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion