Results 1 to 10 of 757
Hybrid View
-
08-16-2014, 02:56 PM #1
- Join Date
- Jul 2014
- Location
- Van Nuys, CA
- Posts
- 22
-
08-16-2014, 03:15 PM #2
- Join Date
- Aug 2014
- Posts
- 627
I spotted this issue after I installed his code so I fell back to the original code and it did the exact same thing. Something funky in the G29 coding, that I can't find, and that is not in the G28 or the G30. I went looking to see if could spot something that was possibly left out of G29 from 28 and 30 but no go.
-
08-16-2014, 03:40 PM #3
- Join Date
- Jul 2014
- Location
- Van Nuys, CA
- Posts
- 22
-
08-16-2014, 03:55 PM #4
- Join Date
- Aug 2014
- Posts
- 627
Well, I did but I wasn't looking for this issue and the problem I had was that my print was jacked up by a lot so all it did was ooze and this may be why. I have printed numerous times just never with auto bed leveling.
-
08-16-2014, 04:10 PM #5
- Join Date
- Jul 2014
- Location
- Van Nuys, CA
- Posts
- 22
-
08-16-2014, 04:27 PM #6
- Join Date
- Aug 2014
- Posts
- 627
I never touched the configuration file just Marlin_Main.cpp. The defines (only define was which corner was home) I temporarily left inside the Marlin_Main.cpp right before G29 but here is my Configuration.h for ABL
Configuration.h
-
08-16-2014, 11:53 PM #7
- Join Date
- Jul 2014
- Location
- Van Nuys, CA
- Posts
- 22
Well, I certainly don't see anything obvious in there. You have this line:
#define XY_TRAVEL_SPEED 8000 // X and Y axis travel speed between probes, in mm/min
8000 seems a little high. Maybe try reducing that to something like 4000, but it doesn't seem like that would be the issue. Are you using the latest Marlin?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help