Results 1 to 10 of 31
Thread: Kossel Mini Build (750/360)
Threaded View
-
06-25-2014, 09:03 AM #19
Is the motor moving both way if you using RAMP test ?
If yes... I dont know... it's software related, but I dont really know the software yet. You're using a "delta" configuration right?
If no...
- Did you ajust the "power" screw ?
- Make sure all the cabling is good. Maybe you didnt connect "Enable A/B" or power is not working.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion