Results 1 to 10 of 25
Thread: Ideas for lasers and resins
Threaded View
-
04-28-2014, 03:26 PM #2
It's a 405nm 20mW, so less powerfull than you have!
Yes, you'll be able to swap the laser. If it dosent fit in the hole, you'll have to make a new support, else it will work. If the laser require too much power, you'll also have to use a 5V relay to open the laser instant of using the circuit directly.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion