Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 14

Threaded View

  1. 10-15-2017, 01:40 PM #12
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Quote Originally Posted by mjf55 View Post
    Is that layer mode? Anyway, Cura 2.7 looks like this. Much better.
    Capture1.JPG

    But still will need supports
    I have All Cura's Just use the 15.04.6

    Also I noticed that in ideaMaker your model has 96 Non-Manifold Edges that need to be fixed.
    When ready to print there will be a little green check-mark in the lower right hand window.
    And I like the Fact that I can add Manually add supports.

    https://www.youtube.com/watch?v=_2G5vahwA8w

    Thank you
    Last edited by Roberts_Clif; 10-15-2017 at 04:23 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules