Results 1 to 10 of 71
Thread: 3D Printed 3D Printer
Threaded View
-
08-03-2017, 06:11 PM #11
And when I pulled the car out of the shop in the morning I parked the c6 right next to my c5..
Making my corvette look good. Not that my corvette is anything less than the best. Here is the crate lsx engine swap:
http://www.mp3car.com/forum/general/...corvette-droid
And the diff swaps are here:
http://www.digitalcorvettes.com/foru...d.php?t=245073
And aside from the gear change there was also a trans swap here:
http://www.digitalcorvettes.com/foru...d.php?t=265177
The track springs went in here:
http://www.digitalcorvettes.com/foru...d.php?t=264817
I am proud to pronounce my accomplishment that my corvette builds 476hp on 87 octane gas. and I get over 20mpg on the highway.Last edited by AutoWiz; 08-03-2017 at 06:21 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion