Results 1 to 10 of 101
Thread: Network Printers
Threaded View
-
07-02-2017, 10:23 PM #11
And Printalicious is all whole and back together and I even adjusted the voltage pot on the power supply so this beast is running at exactly 24 volts..
And I Think this pretty much brings to a close the lion's share of the printer mods that I wanted to make happen. So I have cleaned up my creation station and rewired power so that all of the printers and the pc are going through the battery backup. This way I will never again have to worry about loosing a print to a power surge regardless of the machine I am using...
Now I got some fine tuning to do on all machines and we will see how good they can print. And then we will see how fast they can print good.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion