Results 1 to 7 of 7
Threaded View
-
06-12-2017, 02:35 PM #4
If you bring up the UBL Bed Leveling System, the accuracy of the Z-Probe doesn't really matter. If the probe is super accurate, it save 10 or 15 minutes of setup time. But even with a horrible Z-Probe (or no Z-Probe) you can generate a mesh and fine tune it in 30 or 40 minutes. And from then on... Your "Good to Go".
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)