Results 1 to 9 of 9
Threaded View
-
03-30-2017, 05:53 AM #9
I did need to hold the lever down and push the filament into the feed tube, but it worked fine.
With normal loading and unloading I never use the lever.
used 100% infill on the cube and the overall print time for a 1cm cube was listed as 19 hours !
So yeah, very very very slow :-)
Just make a file for both extruders, keep on the memory card and use whenever using very flexible filaments.
The thing I printed, printed well - but half thickness, which muct be my fault as it was solid with no gapping. Given that it should have been 0.6mm and was 0.33 - somewhere down the line I messed up :-)
***
Ah filament got wrapped round holder spindle. Not me.
The filaflex comes on a very small, totally full spool. So I guess could be prone to this kind of thing. There is literally no rim. Filament ends at the very edge of the spool.
Might have ta respool onto a larger reel - Of fit a cardboard rim. Yeah that would be easier :-)Last edited by curious aardvark; 03-30-2017 at 03:17 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion