Results 1 to 8 of 8
Threaded View
-
01-04-2017, 07:03 PM #6
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Ok, try this. Put the original him on the platform and then go to move and move him down on the Z -.1mm first and run the rafts. Then move him down to -.2mm and run the rafts again. I think the bottom is just uneven.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help