Results 1 to 8 of 8
Threaded View
-
11-28-2016, 04:39 PM #8
- Join Date
- Nov 2016
- Posts
- 11
Well I replaced the glass and got a flat bed and recalibrated the hole printer twice just to make sure and still no change.
I also tried RC7 firmware version to see if that would solve anything, still same end results.
So my only solution now is to go back to the original endstop since I already have invested a lot of time and still have nothing to show for it.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion