Results 1 to 10 of 396
Threaded View
-
12-16-2015, 12:36 PM #10
Yeah... It looks like retract_flag should be within scope. But if you change these line, I think it will compile. You just won't be able to use the 'E' option to force the probe up and down for each sampled point:
Code:#else // AUTO_BED_LEVELING_GRID not defined // Probe at 3 arbitrary points // probe 1 float z_at_pt_1 = probe_pt(ABL_PROBE_PT_1_X, ABL_PROBE_PT_1_Y, Z_RAISE_BEFORE_PROBING, 0, verbose_level); // probe 2 float z_at_pt_2 = probe_pt(ABL_PROBE_PT_2_X, ABL_PROBE_PT_2_Y, current_position[Z_AXIS] + Z_RAISE_BETWEEN_PROBINGS, 0, verbose_level); // probe 3 float z_at_pt_3 = probe_pt(ABL_PROBE_PT_3_X, ABL_PROBE_PT_3_Y, current_position[Z_AXIS] + Z_RAISE_BETWEEN_PROBINGS, 0, verbose_level); clean_up_after_endstop_move(); set_bed_level_equation_3pts(z_at_pt_1, z_at_pt_2, z_at_pt_3); free(plane_equation_coefficients); free(eqnAVector); free(eqnBVector); #endif // AUTO_BED_LEVELING_GRID
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion