Nope, no special code...Never even crossed my mind to change temps while tool change..If you can set the retractions correctly..most of the oozing will be gone. Try printing at a slightly lower temp...my printing PLA at 220 sometimes 200.

Just noticed you are in Miami, where by?

Quote Originally Posted by kablahz View Post
Thanks for sharing. I am still surprised at how well your prints are coming out, kudos on that. Are you using custom tool change gcode or lowering the idle nozzle temperature to prevent oozing? I have only been troubleshooting the dual extruders for a week so I am sure I will eventually get it dialed in, just have to figure out how s3d manages tool change gcode with multiple processes, not sure which tool change gcode is called when changing process and subsequently extruders.