Ive been fighting with abs as well.. Im finally getting some decent prints... And then im gon a rip it apart and replace everything with my new printed parts :-D

If your hexagon came with a fan shroud like mine did to minimally direct air, try flipping the fan so that warm air is pulled up from the bed and part instead of cold air being blown down onto the part.

All of my warps were happening on the back side of the part. After a laptop hd crash and re-setup a firmware update and abl recalibration... Not to mention fighting with octopi... And doing the rough esteps calibration....


Things are currently flat :-) on my second part using glue stick

Clough42s x carraige and fan shroud are 100% printed and flat...

Now to reprint the cold end for an unwarped backip set... Some were only marginally warped... I want flat...