Results 1 to 10 of 476
Thread: Itty Bitty Double Extruder
Threaded View
-
12-07-2014, 06:10 AM #11
- Join Date
- Oct 2014
- Posts
- 8
Hi All
Have printed the main extruder block. It came out pretty well.
I assume we're meant to drill through the bottom where the filament comes out to allow it to go into the hot end.
Maybe I should have also printed it with support (or print cooling) as the 2 recessed areas where the hot ends go aren't so flat due to the bridging it had to do.
Has anyone else had a go and printing this yet?
I used 1.75mm ABS at .2mm layer height.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion