Results 1 to 10 of 396
Threaded View
-
11-14-2014, 07:05 AM #11
- Join Date
- Jun 2014
- Location
- Dearborn, MI
- Posts
- 23
Thanks for the tips. It turns out that the code changes recommended were already in the fork so what I ended up doing was take a dremel and rounded off the micro switch case edge where it was contacting the bed since the interference was pretty small. Problem Solved!! Can post a pic if needed.
Regarding the probe position orientation, it would probably be helpful to put in some short descriptive comments after each probe position on the next fork update. Your explanation was clear and made complete sense, now I have the probe area area perfectly adjusted.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help