Results 1 to 10 of 396
Threaded View
-
10-18-2014, 08:23 PM #11
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
The n4 tells the printer to run the G29 routine with a 4x4 probe point grid. It's from the enhanced G29 code found here: http://3dprintboard.com/showthread.p...ed-G29-command If you're using the firmware fork from this topic, you should already have it installed.
Last edited by AbuMaia; 10-18-2014 at 08:35 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)