Results 1 to 5 of 5
Threaded View
-
05-21-2017, 11:05 AM #1
- Join Date
- May 2017
- Posts
- 2
Need help in diagnosing printing quality problem, picture attached
Hello everyone, below I have a picture of two PLA prints that use the exact same settings and slicer, speed at 30mm/s, 186C. The one on the left came out nearly perfect, the next part I printed, the one on the right came out absolutely terrible and has very poor layer adhesion. I have a Hictop i3 clone with the z axis mod to prevent wobble. I am a bit lost as to what the problem could be but I think it may be an extruder stepper motor issue? I have tried to research this problem but can not find anything like it. Also had an x wobble that would appear in Cura but would be fine in Slic3r with the same print speed. Not sure if these are related but I am now lost as to what step to take next.
printer issue.jpg
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help