Results 1 to 4 of 4
Threaded View
-
01-20-2017, 09:03 AM #1
- Join Date
- Aug 2016
- Posts
- 25
First Print Pegasus 12 X axis issue
After a few months of required attn to some work around my house I finally got around to finishing my first build.
Printed this cube with Hatchbox PLA at 200 ext and 70 bed. .2 layer height. Using S3d and a profile I got from this forum.
As you can see the left side of the X axis is all over the place, the bottom is facing you and did not fill on the left side. My initial thought was loose belt but I could barely get that X belt on because I cut it too short.
Ideas?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help