Itty Bitty Double Extruder

[clough42]

At long last: The hardware kits are here!

http://www.ebay.com/itm/Itty-Bitty-D...-/161542799817

This kit includes all of the miscellaneous hardware required to assemble the Itty Bitty Double Extruder:

• GT2 20-tooth Pulleys with set screws (2)
• GT2 200mm Belts (2)
• 688ZZ 8x16x5mm Bearings (6)
• Extension springs (2)
• Fiberglass/Polyimide insulator
• M2.5x10 socket head cap screws (2)
• M4x.7 hex nuts (2)
• M4x20 button head cap screws (2)
• M3 flat washers (6)
• M3x.5 hex nuts (11)
• M3x25 socket head cap screws (3)
• M3x16 button head socket cap screws (10)
• M3x12 flat head socket cap screws (10)
• M3x8 socket head cap screws (6)
• M3x6 button head socket cap screws (2)

You will also need the printed parts, motors, hobbed bolts, hot ends and fans. The Hexagon hot ends now come with 25mm and 40mm fans that will work. If you order your hot ends from Colin at MakerFarm, be sure to let him know you need the 25mm fans.

[AbuMaia]

At long last: The hardware kits are here!

**POUNCE!!** Thanks!

[bstag]

Thanks for putting the hardware kit up. Order placed.

[rhonal89]

Will this work on makerfarm 12 i3v. So I can buy a couple of kits from clough42.

[adamfilip]

I ordered a set! thanks

[adamfilip]

Where can I get the Nema 14's?

[TopJimmyCooks]

Where can I get the Nema 14's?

One very reputable vendor:
http://www.pololu.com/product/1209

Will this work on makerfarm 12 i3v. So I can buy a couple of kits from clough42.

Yes, X carriage is the same on all three sizes.

[kd7eir]

I do not do ebay, can I arrange to buy one directly from you?

[adamfilip]

I found some Nema 14 in canada here

http://www.canadarobotix.com/stepper...mm-2-7v-1000ma

[beerdart]

First dual print still tweaking settings and offsets but getting close. I had to make a new duct out of aluminum as the custom/homemade hot ends im using are too close for the plastic one even with insulation. Also using the print cooling fan modified for cold end cooling as the 25mm was just not enough flow.