Results 1 to 10 of 476
Thread: Itty Bitty Double Extruder
Hybrid View
-
11-30-2014, 01:27 PM #1
Good to hear, I'm also using the Sunon maglev 3CFM fan and those are the Temps I'm printing at and about the same temps i'm seeing on the heat sink fins for my single extruder.
One mod I did make to the single hexagon shroud was to remove the plastic at the bottom between the hot end and cooling fins and replace it with a piece of brass that is cut to go around the hot end and wrap up the sides, this is attached with a couple of m2 bolts and nuts. This stays cool and avoids the melting plastic issue. Looks like I'll be doing the same to the double shroud as well.
Thanks for all the time and effort you have put into this project.
-
11-30-2014, 10:19 PM #2
-
01-12-2015, 03:33 AM #3
- Join Date
- Jan 2015
- Location
- NZ
- Posts
- 2
Hello can I order a hardware kit to be shipped to New Zealand?
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials