Marlin firmware fork for MakerFarm i3v w/ auto bed level & Roxy's enhancements

[printbus]

I believe hypot is an Arduino function. It wouldn't be defined in the Marlin files.

[AbuMaia]

I don't have to check, I know I have it enabled and set to 1000. All commenting it out will do is cause Marlin to skip that part, as the "if" will no longer match. The unmodified version from the zip file compiles properly. It's something to do with my settings somehow.

Oh, I see, the unmodified version has that line commented out, too. Hmm. Yes, if I activate that line, it throws that error.

I'm reverting back to my old Marlin. My servo jitters constantly without the deactivation delay, and I don't trust it to be accurate when homing or bed level probing.

[ctcwhexdx]

Something else to look at in the configuration.h, right about that line it says :
//If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk
//The value is the delay to turn the servo off after powered on - depends on the servo speed; 300ms is good value, but you can try lower it.
// You MUST HAVE the SERVO_ENDSTOPS defined to use here a value higher than zero otherwise your code will not compile.

I don't have to check, I know I have it enabled and set to 1000. All commenting it out will do is cause Marlin to skip that part, as the "if" will no longer match. The unmodified version from the zip file compiles properly. It's something to do with my settings somehow.

Oh, I see, the unmodified version has that line commented out, too. Hmm. Yes, if I activate that line, it throws that error.

[AbuMaia]

Jeez. Looks like I'll be needing to download the newer code to help out where I can. I don't have the code with the retract_z_probe function in it. BUT, looking at the number of other places in marlin_main.cpp that where similar code exists in the older version, I'll bet the 'void retract_z_probe()' should really be 'void retract_z_probe(int axis)'.

I tried that, it threw many more errors which I can't remember well enough to quote right now.

Something else to look at in the configuration.h, right about that line it says :
//If defined, the Probe servo will be turned on only during movement and then turned off to avoid jerk
//The value is the delay to turn the servo off after powered on - depends on the servo speed; 300ms is good value, but you can try lower it.
// You MUST HAVE the SERVO_ENDSTOPS defined to use here a value higher than zero otherwise your code will not compile.

Yes, I saw that too. I used the deactivation delay before this fork came out, so it was working properly before. I have it set up properly.

Comparing the new version with what I was using yesterday, that whole "Retract Z Servo endstop if enabled" section is new. I commented it all out for now.