Marlin firmware fork for MakerFarm i3v w/ auto bed level & Roxy's enhancements

[BgHurt]

I too have the issue of the Z axis not raising after the G28 before retractions. I put some debug code into the G28 to see if it was indeed running the do_blocking_move(blah, blah, +Z_RAISE_BETWEEN_PROBINGS)

It does run the command, but it never actually does the move on my arduino. Not sure if it is already in the middle of something so the function never runs. or if the move is no good. Not sure, but regardless it never lifts the Z before it retracts.

Stock dacb, just compiled and pushed to my RAMPS. Didnt work, so I put some SERIALPGM's in to get where it was in the program loops.