Slicer won't bridge this gap nicely ????

[Roxy]

I'm trying Cura right now with your settings as close as possible. (I have a .4 mm nozzle and 3mm filament, so obviously there have to be some changes.) It would have been good to take a picture of the slot cut into the block. This is going to be a nut trap on a X-Motor-End for a Prusa i3.

No Go! It tried to tack the filament back and forth across the gap, but it didn't stick and there wasn't enough there to provide support for the next layer. I'm bumping the advanced speeds down right now... Trying again:

Still No Go!

Back to fighting with Slicer!!!

PS. THANKS SO MUCH for giving it a whirl!