Quote Originally Posted by mjf55 View Post
To be honest, I have no idea how you managed to print even 1 of these wing inserts if all you did was add a raft, unless you rotated it.. The point is very small, and the vertical part that does not touch the bed, would just create a mess. You cannot start printing part mid air, as that part tries to. Lay the part down, No raft would be required. I suspect that would work fine.
If you can post a picture of an already built (successful) part, that will show which way the layers are put down, as we may be able to see how it was done.
Yes, I know it did say not to use support, but I ran into that same issue....You can't print mid-air. I did support material, raft and skirt. I always verify bed level because it's recommended :-)
Here is a pic of the last successful print, along with the support that prints under the floating side. Thank you for trouble shooting this with me! I am afraid to try and print anything else, beyond that I need that last one to print.
22556205_1621883494536301_1673103951_o.jpg