Results 1 to 10 of 14
Hybrid View
-
10-15-2017, 11:26 AM #1
- Join Date
- Jul 2017
- Posts
- 193
RC, he is using IdeaMaker as the slicer https://www.raise3d.com/pages/ideamaker
Im also thinking he is having problems on the upper supports, as he says "The tube went fine so far but the mount did fall off the tube!" , but perhaps i'm reading into it.
-
10-15-2017, 11:46 AM #2
I was just testing the Ears. as far as the upper ears with Proper Support they should be just a strong as the lower ears.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion