Close



Results 1 to 2 of 2
  1. #1

    Exclamation 3D printer (tronxy diy kit from gearbest) Dosnt get to the correct heat

    Hi, Whenever I set my printer to lets say 210 degrees, it gets stuck at about 190, i have tried changing the fan settings, please help

  2. #2
    Engineer Marm's Avatar
    Join Date
    Sep 2014
    Posts
    630
    Add Marm on Thingiverse
    Well.... I'm not familiar with that printer, what software are you using to slice? Is it setting the gcode to the correct temp?

    If all your settings look kosher, get out your trusty multimeter, and see what the current/voltage is at the hot end. Check the same at the board, make sure you're not losing power somewhere. Then check with the manufacturer and find out what the hot end should be pulling. If it's not close, then you have a hardware issue.

    But I'd guess it's a setting somewhere.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •