New generic stepper motor issue?

[Kevin37]

Hi im new to this forum and i have a question, I bought some high torque stepper motors to upgrade my custom 3d printer and I can't seem to figure out what wires go where on my ramps board 2B 2A, 1A, 1B. The motors are 17hd60001-22b by busheng. They didn't come with a scymatic and any help would be greatly appreciated. Here are the specs... Thank you in advance.

Specs:
1m wire, one connect electrical machine, on the other end has variety optional ports; heat shrink tubing effect to prevent the wire tangled up
D-shaped axle with 22mm, electrical machine with high-torque, high-speed, low noise
Suitable for 17HD60001-22B mixing type stepping motor
Outside view: Shown as the pictures
Drive mode: Chopping wave constant current drive
Exciting mode: Two-phase 4-wire. It is available for rotation of forward and reverse
Swerve: The order of power is AB-BC-CD-DA, from shaft end to see C.W
Rated current (one-phase): 1.5A DC
Rated voltage: 2.4V
Stepping angle: 1.8
Insulation grade: B grade
Specifics:
Operating Conditions: Environment Temperature: -20~50 ; RH: 90%MAX; Mounting Position: Axis horizontal or vertical installation
Direct-current winding resistance (25 ): 1.6 10%
Wnding inductance: 3.6mH 20%
Cogging torque: 40mN.m REF
Holding torque: 600mN.m I=1.5A
Max. no-load starting frequency: 1200pps
Max. no-load running Frequenc: 8000pps