Well I ran through the normal leveling process and I found that the Z-axis was off which explains having more issues on the right side of the print. I tried several times to print in PLA (the filament I am usually successful with) but with no success. I noticed that the filament seem to be slipping a little. I tried changing the tension on the Flexion from 3 to 2 and it magically started working. Every where that I have found says to set it to 4 for hard filaments like PLA but I guess it all depends on manufacture. I did notice that this filament is a little bit more flexable then the last I got from the same company.