Results 1 to 6 of 6
Thread: Technical Information Resources
Hybrid View
-
11-23-2015, 09:43 AM #1
http://reprap.org/wiki/Print_Trouble...ictorial_Guide
http://support.3dverkstan.se/article...shooting-guide
https://www.simplify3d.com/support/p...oubleshooting/
https://all3dp.com/common-3d-printin...eir-solutions/
https://ultimaker.com/en/support/vis...shooting-guide
...
I'm sure your google-fu is adequate.
http://manual.slic3r.org is as good a place to start as any.
-
05-05-2022, 05:21 AM #2
- Join Date
- May 2022
- Posts
- 2
Printing speed
I’m having issues with my first layer speed. I did set the speed lower in cura but for some reason when come to certain areas it will speed up very quick not laying filament properly ending in failed first layer… ideas?
-
05-05-2022, 10:48 AM #3
- Join Date
- May 2022
- Posts
- 2
-
05-05-2022, 12:56 PM #4
- Join Date
- May 2020
- Posts
- 622
I am not as knowledgeable about Cura or any slcicer as I would like to be so I can only offer any information that occurrs to me.
At a guess it will be a setting somewhere in the numerous speed settings, could even be the travel speed, typically in my slicer it's set at 100mm/sec.
I think it is really a matter of experimenting with various settings, slower is very often better than risking a ruined print.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials