Results 1 to 10 of 38
Thread: This could work
Threaded View
-
01-21-2014, 02:10 PM #11
- Join Date
- Jan 2014
- Posts
- 16
The rods are just not in the sketch. There are many ways to keep it in place, i just havent really thought about what could be the best.
The flow of water can be controlled the same way the original does. (Dont ask me how, that and the mirror movement are the two things i havent really grasped yet.) The same sensor and tap are in place, so probably just manually setting the tap to a certain drop rate and measuring it with the mic.
Wait, i just thought about something:
printersketchabove.jpg
Its the two containers from above. Assuming its two plastic container, will probably need to place some metal L plates to the four sides of the outer container, where we cut into the plastic.
Ps: as i stated before, the territory of the outside container must be twice of the territory of the inside container
Edit: forget it, this is way more simple (metal rails are fixed on the outer container):
printersketchabove2.jpgLast edited by masterada; 01-21-2014 at 04:18 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion